Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| test-and-measurement:discovery-power-supply-3340:specifications [2022/09/19 15:18] – [Table] Alin Craciun | test-and-measurement:discovery-power-supply-3340:specifications [2022/10/04 11:38] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Discovery Power Supply (DPS3340) Specifications ====== | ||
| + | <WRAP round todo> | ||
| + | === Under Construction! === | ||
| + | </ | ||
| + | ~~TechArticle~~ | ||
| + | These specifications are valid following FIXME minutes of warm-up and are typical at FIXME °C unless otherwise noted. | ||
| + | |||
| + | ===== Power Supplies ===== | ||
| + | All channels are independently controllable with independent current and voltage settings. | ||
| + | |||
| + | |<100% 15% 15%>| | ||
| + | ^ Specification | ||
| + | ^ DC Output Rating | ||
| + | | ::: | **Current** | ||
| + | ^ Maximum Power | ||
| + | | ::: | ||
| + | ^ DC Accuracy | ||
| + | | ::: | **Current** | ||
| + | ^ Load Regulation | ||
| + | | ::: | **Current** | ||
| + | ^ Line Regulation | ||
| + | | ::: | **Current** | ||
| + | ^ Ripple and Noise | **Voltage** \\ (20 MHz Bandwidth): | ||
| + | | ::: | ::: | ::: | ::: | ::: | | ||
| + | | ::: | **Current** \\ (20 MHz Bandwidth): | ||
| + | ^ Setting Resolution | ||
| + | | ::: | **Current** | ||
| + | ^ Meter Resolution | ||
| + | | ::: | **Current** (across -Imax....+Imax interval) | ||
| + | ^ Meter Accuracy | ||
| + | | ::: | **Current** | ||
| + | |||
| + | === Isolation Voltage === | ||
| + | Device isolated from network through external supply. Outputs share a common GND between them and with the host PCB USB connector. | ||
| + | |||
| + | === Protection Circuitry === | ||
| + | All three supplies feature overcurrent protection through software-settable current limits that can be applied individually to each channel. Same-polarity aggressor protection and reverse voltage protection work up to ±15 V. | ||
| + | |||
| + | === Tracking Mode === | ||
| + | When the software-implemented tracking mode is active, Outputs 2 and 3 will track each other in absolute value by applying any voltage change made to one channel' | ||
| + | |||
| + | ~~REFNOTES~~ | ||
| + | ---- | ||
| + | ===== Connectivity ===== | ||
| + | The DPS3340 requires a host computer running the WaveForms software connected via USB to operate. | ||
| + | |||
| + | ^ Device to Computer Interface | ||
| + | |||
| + | ---- | ||
| + | ===== Power Requirements ===== | ||
| + | The DPS3340 requires an auxiliary power supply. | ||
| + | |||
| + | ^ Power Supply Voltage | ||
| + | ^ Power Supply Current | ||
| + | ^ Power Consumption | ||
| + | ^ Barrel Connector Size | 5.5 mm x 1.65 mm | | ||
| + | |||
| + | ---- | ||
| + | ===== Physical Characteristics ===== | ||
| + | |<100% 25%>| | ||
| + | ^ Dimensions | ||
| + | ^ Weight | ||
| + | |||
| + | ---- | ||
| + | ===== Environmental ===== | ||
| + | |||
| + | |<100% 25%>| | ||
| + | ^ Operating Temperature | ||
| + | ^ Storage Temperature | ||
| + | ^ Operating Humidity | ||
| + | ^ Storage Humidity | ||
| + | ^ Cooling | ||
| + | ^ Pollution Degree | ||
| + | ^ Maximum Altitude | ||
| + | |||
| + | Indoor use only | ||
| + | ~~REFNOTES~~ | ||
| + | ---- | ||
| + | ===== Certifications ===== | ||
| + | ---- | ||

