Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
test-and-measurement:analog-discovery-studio:canvases:interposer-canvas:reference-manual [2021/06/02 20:19] – Arthur Browntest-and-measurement:analog-discovery-studio:canvases:interposer-canvas:reference-manual [2022/10/04 11:38] (current) – external edit 127.0.0.1
Line 35: Line 35:
 The Analog Discovery Studio can supply up to 1 Amp of current to the FPGA board through the Interposer Canvas's USB connector. The power budget is shared with the fixed +5V rail on the Interposer Canvas, so the current draw from that rail into custom circuitry may further limit the power available to the FPGA (and vice-versa). If the FPGA board and custom circuitry attempt to draw more current than can be provided by the Analog Discovery Studio, a brown-out event may occur, temporarily turning off the board and returning it to a known good state. The Analog Discovery Studio will continue to operate as normal in this event. The Analog Discovery Studio can supply up to 1 Amp of current to the FPGA board through the Interposer Canvas's USB connector. The power budget is shared with the fixed +5V rail on the Interposer Canvas, so the current draw from that rail into custom circuitry may further limit the power available to the FPGA (and vice-versa). If the FPGA board and custom circuitry attempt to draw more current than can be provided by the Analog Discovery Studio, a brown-out event may occur, temporarily turning off the board and returning it to a known good state. The Analog Discovery Studio will continue to operate as normal in this event.
  
-Alternatively, the FPGA board can be powered externally through the barrel jack of whichever board is used. Important: When using an external power supply, to ensure that no damage to either device occurs, make sure to connect the ADS's power supply before connecting the power supply to the FPGA board.  +Alternatively, the FPGA board can be powered externally through the barrel jack of whichever board is used. Important: When using an external power supply, to ensure that no damage to either device occurs, make sure to connect the Analog Discovery Studio's power supply before connecting the power supply to the FPGA board. 
- +
-"FIXME (option 1, 2, or 3, will be chosen pending further testing) Important: (1.) When using an external power supply, to ensure that no damage to either device occurs, make sure to connect the ADS's power supply before connecting the power supply to the FPGA board. (2.) Do NOT use an external power supply with your FPGA board while it is connected to the Interposer Canvas, in order to prevent damage that may occur to the devices. (3.) We cut this whole 'important' bit since everything is safe and nothing will break."+
  
 ----- -----
Line 49: Line 47:
 Four fixed supplies are available: +12V, -12V, 5.0V, and 3.3V. Four fixed supplies are available: +12V, -12V, 5.0V, and 3.3V.
  
-Green status LEDs, associated with each supply, turn on when power is available on that pin (when the supply is enabled, and the ADS is turned on).+Green status LEDs, associated with each supply, turn on when power is available on that pin (when the supply is enabled, and the Analog Discovery Studio is turned on).
  
 Since each power supply is sourced directly from the Analog Discovery Studio, the minimum and maximum current and power available for each supply depends on the Analog Discovery Studio's specifications. See the [[..:..:specifications#power_supplies|Analog Discovery Studio Specifications]] for more information. Since each power supply is sourced directly from the Analog Discovery Studio, the minimum and maximum current and power available for each supply depends on the Analog Discovery Studio's specifications. See the [[..:..:specifications#power_supplies|Analog Discovery Studio Specifications]] for more information.