Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
test-and-measurement:analog-discovery-pro-3x50:programming-an-fpga [2021/10/15 20:46] – [Programming an FPGA Board with the Analog Discovery Pro (ADP3450/ADP3250)] Arthur Browntest-and-measurement:analog-discovery-pro-3x50:programming-an-fpga [2022/10/04 11:38] (current) – external edit 127.0.0.1
Line 1: Line 1:
 ====== Programming an FPGA Board with the Analog Discovery Pro (ADP3450/ADP3250) ====== ====== Programming an FPGA Board with the Analog Discovery Pro (ADP3450/ADP3250) ======
  
-<WRAP center round todo 60%> +<WRAP group> 
-This page is under construction. +There might be cases when you need to provide a complex stimulus to a circuit, or you might want to condition digital signals before measurement, in both cases using an FPGA board can be handy. However, FPGA boards are usually configured from a PC, so including them in a standalone measurement system might not have been an option until now.
-</WRAP>+
  
-<WRAP group> 
 This guide walks you through the steps required to use the Analog Discovery Pro to load a previously-created bit file to your Digilent FPGA board. This guide walks you through the steps required to use the Analog Discovery Pro to load a previously-created bit file to your Digilent FPGA board.
 </WRAP> </WRAP>
Line 21: Line 19:
 </WRAP></WRAP> </WRAP></WRAP>
  
 +You will also need a bit file to load onto the FPGA board.
 +----
 ===== Installing the Adept Utilities ===== ===== Installing the Adept Utilities =====
 <WRAP group> <WRAP group>
Line 50: Line 50:
 </WRAP> </WRAP>
 </WRAP> </WRAP>
 +----
 ===== Loading the Bit File ===== ===== Loading the Bit File =====
 <WRAP group> <WRAP group>