This is an old revision of the document!

JTAG-SMT4 Resource Center

Buy Reference Manual Technical Support
JTAG-SMT4
Surface-mount Programming Module
Features
  • Small, complete, all-in-one JTAG programming/debugging solution for Xilinx FPGAs with three UART side channels
  • Compatible with Xilinx Tools (version 2020.1 or newer required)
  • High-Speed USB 2.0 port that can drive JTAG bus up to 30Mbit/sec (frequency settable by user)
  • Open drain buffers allow PS_SRST_B and PS_POR_B pins to perform software-based resets of Xilinx’s Zynq® platform
  • Quad channel USB controller provides simultaneous access to JTAG and UART interfaces
  • Onboard buffers allow JTAG signals to operate at voltages from 1.8V to 3.3V
  • Small form-factor surface-mount module can be directly loaded on target boards
  • USB D+ and D- signals routed to pads, allowing USB connector to be placed anywhere on the host PCB
  • VBUS_DETECT pin allows for reduced current consumption when the module isn’t connected to a PC
Software
Adept
Adept 2 (Redirect)
Product Compliance
HTC
8473301180
ECCN
EAR99

This page has been moved, the new location is JTAG-SMT4 Reference Manual.

Documentation

, , ,