Differences

This shows you the differences between two versions of the page.

--- programmable-logic:guides:vivado-add-microblaze [2021/07/30 22:13] – [Add a Microblaze Processor to a Block Design] Arthur Brown
+++ programmable-logic:guides:vivado-add-microblaze [2022/10/04 11:38] (current) – external edit 127.0.0.1
@@ Line 5: / Line 5: @@
 **Note:** //This section is intended for use with boards without a Zynq chip. For Zynq boards, the Zynq7 Processing System should be used instead.//
+**Note:** //If you aren't sure whether your board has DDR memory, check the //Memory// column of the specification table on this site's [[programmable-logic:start]] page.//
 --> Follow the steps in this dropdown for boards without DDR memory #
 <WRAP group>
 <WRAP group> <WRAP column half>
-First, an external clock should be added to the block design, so that it can be used to generate any other clocks required by the design. Open the **Board** tab, and find the system clock. Right click on it and select **Connect Board Component**.
+First, an external clock should be added to the block design, so that it can be used to generate any other clocks required by the design. Open the **Board** tab, and find the system clock. Right-click on it and select **Connect Board Component**.
 </WRAP> <WRAP column half>
 {{ :learn:programmable-logic:tutorials:2020.1:add-microblaze-processor:microblaze-1.png?600 |}}