Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| programmable-logic:basys-2:start [2022/09/12 11:41] – changed forum.digilentinc.com to forum.digilent.com jeff.greenberg_ni.com | programmable-logic:basys-2:start [2022/10/04 04:38] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ~~NOTOC~~ | ||
| + | | ||
| + | ====== Basys 2 ====== | ||
| + | **Note**: The Basys 2 was replaced by the [[programmable-logic: | ||
| + | |||
| + | {{Digilent Infobox | ||
| + | | Store Page = https:// | ||
| + | | Manual = [[reference-manual]] | ||
| + | | Support = https:// | ||
| + | | Title = Basys 2 | ||
| + | | Subtitle = Spartan-3E FPGA Trainer Board | ||
| + | | Header = Key Specifications | ||
| + | | Flash ROM = XCF02 Platform stores FPGA \\ configurations indefinitely | ||
| + | | Multipliers = 18-bit | ||
| + | | Gates = 100K (250K*) | ||
| + | | Block RAM = 72Kbits | ||
| + | | Internal clock = 300MHz+ | ||
| + | | Oscillator = User-settable frequency (25, \\ 50, 100MHz) | ||
| + | | Header = Connectivity and Onboard I/O | ||
| + | | Pmod Connectors = Four 6-pin Pmod ports | ||
| + | | VGA = 1 8-bit VGA connector | ||
| + | | PS/2 = 1 PS/2 port | ||
| + | | Switches = 8 | ||
| + | | Buttons = 4 | ||
| + | | LEDs = 8 | ||
| + | | Header = Electrical | ||
| + | | Power = Three on-board voltage regulators \\ (1.2V, 2.5V, and 3.3V) that allow use \\ of 3.5V-5.5V external supplies | ||
| + | | Logic Level = 3.3V | ||
| + | | Header = Physical | ||
| + | | Width = x in | ||
| + | | Length = y in | ||
| + | | Header = Design Resources | ||
| + | | Master UCF Files = {{: | ||
| + | | Header = Documentation | ||
| + | | Primary IC = [[https:// | ||
| + | | Reference Manual = [[programmable-logic/ | ||
| + | | Schematic = {{: | ||
| + | }} | ||
| + | |||
| + | |||
| + | |||
| + | {{page> | ||
| + | |||
| + | *250k gates were used in early models of the Basys 2 but are no longer available. Both models are fully pin-compatible. | ||
| + | |||
| + | |||
| + | ===== Tutorials ===== | ||
| + | {{topic> | ||
| + | |||
| + | ---- | ||
| + | ===== Example Projects ===== | ||
| + | {{topic> | ||
| + | |||
| + | ---- | ||
| + | ===== Additional Resources ===== | ||
| + | ---- | ||
| + | |||
| + | {{tag> | ||

