Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
pmod:pmodamp2:start [2022/09/13 15:24] – changed forum.digilentinc.com to forum.digilent.com jeff.greenberg_ni.compmod:pmodamp2:start [2022/10/04 11:38] (current) – external edit 127.0.0.1
Line 1: Line 1:
 +~~NOTOC~~ 
 +   
 +====== Pmod AMP2 ======
  
 +  
 +{{Digilent Infobox
 +| Store Page = https://digilent.com/shop/pmod-amp2-audio-amplifier/
 +| Manual = [[reference-manual]]
 +| Support = https://forum.digilentinc.com/forum/7-add-on-boards/
 +| Title = Pmod AMP2
 +| Subtitle = Audio Amplifier
 +| Header = Features
 +| Bullet = Filterless, high efficiency audio amplifier
 +| Bullet = Monophonic audio output
 +| Bullet = Standard 1/8“ (0.32 cm) mono speaker jack
 +| Bullet = Micropower shutdown mode
 +| Bullet = Pop-and-click suppression
 +| Bullet = Digital gain select
 +| Bullet = 6-pin Pmod port with GPIO interface
 +| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}} Type 1
 +| Header = Electrical
 +| Bus = [[learn/fundamentals/communication-protocols/gpio/start | GPIO]]
 +| Specification Version = 1.2.0
 +| Logic Level = 3.3V
 +| Header = Physical
 +| Width = 1.25 in (3.17 cm)
 +| Length = 0.80 in (2.03 cm)
 +| Header = Design Resources
 +| Fritzing Part = {{reference:pmod:pmodamp2:pmodamp2.fzpz| }}
 +| Header = Documentation
 +| Primary IC = [[http://www.analog.com/static/imported-files/data_sheets/SSM2377.pdf | SSM2377]]
 +| Reference Manual = [[pmod/pmodamp2/reference-manual]]
 +| Schematic = {{:reference:pmod:pmodamp2:pmodamp2_sch.pdf| }}
 +| Header = J1 Pinout
 +| Full Row = {{ :reference:pmod:pmod-pinout-1x6.png?direct |}}
 +| Pin 1 = AIN
 +| Pin 2 = GAIN
 +| Pin 3 = NC
 +| Pin 4 = ~SHUTDOWN
 +| Pin 5 = GND
 +| Pin 6 = VCC
 +}}
 +
 +{{page>reference-manual}} \\ \\
 + 
 +
 +
 +===== Example Projects =====
 +
 +==Microprocessor==
 +  * [[learn/software/tutorials/digilent-core-install/start | Installing the Digilent Core for Arduino]]
 +  * {{:reference:pmod:pmodamp2:amp2_library_example.zip|Library and Example code}}
 +  * {{:reference:pmod:pmodamp2:uc32amp.zip|UART serial-controlled uC32 AMP2 controller with non-blocking delays}}
 +
 +==Programmable Logic==
 +  * [[learn/programmable-logic/tutorials/pmod-ips/start | Getting Started with Digilent Pmod IPs]]
 +    * Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier.
 +
 +----
 +
 +===== Additional Resources =====
 +  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}}
 +
 +----
 +
 +
 +{{tag>pmod pmod-start pmod-gpio pmodamp2 audio-amplifier resource-center}}