Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
learn:programmable-logic:tutorials:zedboard-getting-started-with-zynq:start [2017/01/20 22:41] – [11. Run the Project] jon peyronlearn:programmable-logic:tutorials:zedboard-getting-started-with-zynq:start [2022/10/04 11:38] (current) – external edit 127.0.0.1
Line 74: Line 74:
 >1.6) Select **Boards** and select the **Zedboard** board file. Click **Next** and then **Finish**. >1.6) Select **Boards** and select the **Zedboard** board file. Click **Next** and then **Finish**.
 >  > 
->{{:reference:programmable-logic:zedboard-getting-started-with-zynq:image_6.jpg?600|}}+>{{:learn:programmable-logic:tutorials:zedboard-getting-started-with-zynq:board_file_zedboard.jpg?600|}} 
 + 
 +<WRAP center round tip 60%>  
 +Make sure to select the board file made by Digilent. 
 +</WRAP>
 ----- -----
 ==== 2. Creating a New Block Design ==== ==== 2. Creating a New Block Design ====
Line 289: Line 293:
 >11.2) Save the project.  The project will automatically build. >11.2) Save the project.  The project will automatically build.
  
->11.3) Right click the **getting_started_with_ZYBO** directory and select run as -> Launch on Hardware(System Debugger).+>11.3) Right click the **zedboard_getting_started_with_zynq** directory and select run as -> Launch on Hardware(System Debugger).
  
 >{{:learn:programmable-logic:tutorials:zybo-getting-started-with-zynq-server:echo_server_zynq_13.jpg?direct&600|}} >{{:learn:programmable-logic:tutorials:zybo-getting-started-with-zynq-server:echo_server_zynq_13.jpg?direct&600|}}
  
->11.4) The demo will be running on the ZYBO. Try playing around with the 4 switches (labeled SW0-SW3). Doing so should light its respective LED. Also over the serial port, pressing each button (labeled BTN0-BTN3) will produce the message "button x pressed".+>11.4) The demo will be running on the Zedboard. Try playing around with the 4 switches (labeled SW0-SW3). Doing so should light its respective LED. Also over the serial port, pressing each button (labeled BTN0-BTN3) will produce the message "button x pressed".
  
 >11.5) Tera Term or any serial terminal will work as a Console for displaying the output of the BTN's. >11.5) Tera Term or any serial terminal will work as a Console for displaying the output of the BTN's.
Line 302: Line 306:
  
 ----- -----
 +
 +
 +{{tag>learn programmable-logic tutorial zedboard}}