This is an old revision of the document!

Adding Digilent FPGA Boards to Multisim

This guide will provide a step by step tutorial of how to add a Digilent FPGA board to Multisim. To program your FPGA board through Multisim, follow this guide: Programming Digilent FPGA Boards Through Multisim.

Prerequisites

Note: This same process can be applied to earlier FPGA boards, but instead of Vivado, Xilinx ISE is required. This tutorial will only focus on utilizing Vivado.

Create and Modify the Configuration Files

Download the Constraints File

Multisim needs two configuration files specific for the chosen FPGA board. These two are an *.xdc and a *.mspc file. The xdc file is called constraints file (Xilinx Design Constraints) and contains the assignments of physical FPGA chip pins to HDL code. You can also think of this file like the name definitions for physical pins, so later, in your “code” you only have to use the name, not the pin number. For more information on constraints files, read: What is an XDC File? (Redirect).

For Digilent boards, you can find the xdc file specific to your board on the bottom right hand side of the board's resource center, or on this page. Download the file for your board.

Note: In this guide, an Arty-S7-50 will be used.

Note: If you are using an earlier board, compatible with Xilinx ISE, instead of the xdc file, you will need a *.ucf file.

Create the Configuration File

Open the downloaded constraints file in a text editor, then create an empty file, with the same name, but the *.mspc extension. This file will contain the available pins in Multisim PLD design.

First, create the header and the “body” of the file. The language is similar to HTML, is easily readable. For the file to be compatible with your board, you will have to change the Name, PartNumber, BoardName, Family, Device, Package and Ucf fields. You can leave the other fields as they are. 

<PLDConfiguration Version="1.0">
    <Component Name="Digilent Arty S7-50" PartNumber="XC7S50" Version="1.0" OpVoltageInput="3.3" OpVoltageOutput="3.3" OpVoltageBidirectional="3.3" BoardId="">
		<DeviceList BoardName="Digilent Arty S7-50">
			<XilinxDevice Manufacturer="Xilinx" Family="Spartan-7" Device="XC7S50" Package="CSGA324" Speed="-1" DeviceOffset="1" DeviceId="" Ucf="Arty-S7-50-Master.xdc" />
		</DeviceList>
		<ProgrammingProperties>
			<Interface CableTarget="digilent_plugin"/>
		</ProgrammingProperties>
		<Pins Locked="1">
 
        	</Pins>
	</Component>
</PLDConfiguration>

The Name and BoardName fields contain the name of the board. This is how the board will appear in Multisim.

The PartNumber and Device fields contain the name of the FPGA chip. This usually can be found in the board's Reference Manual, or you can find it by plugging in the board and starting Adept.

The Family of the FPGA chip appears in the board's Reference Manual. In this case, a Spartan-7 FPGA is used.

The Ucf field contains the name of the xdc file.

The most tricky property is the Package. You can search the Reference Manual for information about the package of the chip, or you can take a look on the chip itself, or the sticker placed on the chip (the sticker might contain other information as well).

Modify the Constraints File

In the constraints file, delete the “#” mark before the lines describing the resources you want to use. Also change the name of these pins to names you can easily remember (the names shouldn't contain special characters).

Fill in the Configuration File