Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
learn:instrumentation:tutorials:openlogger:log-on-boot [2019/10/14 22:44] – Andrew Holzerlearn:instrumentation:tutorials:openlogger:log-on-boot [2022/10/04 11:38] (current) – external edit 127.0.0.1
Line 1: Line 1:
 ====== OpenLogger - Log on Boot ====== ====== OpenLogger - Log on Boot ======
  
-This guide describes how to to get log on boot working for the OpenLogger.+Log on Boot configures the OpenLogger to automatically start logging data after it has finished booting, without the need to open WaveForms Live. 
 + 
 +This guide describes how to to get Log on Boot working for the OpenLogger.
  
 ==== Configure the OpenLogger ==== ==== Configure the OpenLogger ====
Line 8: Line 10:
 <WRAP column half> <WRAP column half>
  
-On waveformslive.com, click on the connected OpenLogger to connect to the device and navigate to the //Instrument Panel//. In the control panel to the right, expand the //Advanced// section. Click the Log On Boot toggle to enable it. When enabled, the device will save the current parameters to a file that is read when the OpenLogger boots. In the case of logging to SD, the device will check to see if the SD exists, wait for the SD card file system to initialize and then start logging if all is good.+On waveformslive.com, click on the connected OpenLogger to connect to the device and navigate to the //Instrument Panel//.  
 + 
 +In the control panel to the right, expand the //Advanced// section.  
 + 
 +Click the Log On Boot toggle to enable it. Clicking 'Refresh' to apply the new Log on Boot settings. 
 + 
 +When enabled, the device will save the current parameters to a file that is read when the OpenLogger boots. If set to log to SD, the device will check to see if the SD card exists, wait for the SD card file system to initialize and then start logging if all is good.
  
 </WRAP> </WRAP>