Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
learn:instrumentation:tutorials:analog-discovery-studio-network-analyzer [2019/05/24 21:03] – Ian Etheridgelearn:instrumentation:tutorials:analog-discovery-studio-network-analyzer [2022/10/04 11:38] (current) – external edit 127.0.0.1
Line 1: Line 1:
-======Using the Network Analyzer====== +======Using the Network Analyzer (Page has Moved) ======
-====1. Opening the Network Analyzer==== +
-==1.1== +
-Plug in your <test & measurement device>, then start WaveForms and make sure your device is selected.+
  
-==1.2== +<WRAP round important 660px> 
-Once the Welcome page loads, in the instrument panel at the left side of the window, click on the Network button to open the Network Analyzer instrument.+This guide has been replaced by [[test-and-measurement:guides:waveforms-network-analyzer]], and is slated to be removed from the Digilent Wiki. Please update all bookmarks and saved links to the new location. 
 +</WRAP>
  
- +{{tag>to-be-removed}}
-==1.3== +
-Once the Network instrument opens, the window contains the plot plane split horizontally into two subplot planes, the control bar above the plot planes, and the configuration panel to the right of the plot plane.  +
- +
-====2. Using the Network Analyzer==== +
- +
-==2.1 Hardware Setup== +
-Connect the <test&measurement device>'s scope channel 1 pin (orange wire) to the device's wavegen channel 1 output pin (yellow wire). For devices that use differential input channels, such as the Analog Discovery Studio with MTE cables, make sure to connect the scope channel 1 negative pin (orange wire with white stripes) to the ground pin associated with wavegen channel 1 (black wire). +
- +
-==2.2 Run the Network Analyzer== +
-By default, the Network Analyzer uses the <test&measurement device>'s wavegen channel 1 as the source signal and does not need any further configuration from the wavegen instrument window. From the control bar, click Run to continuously sweep the connected network port(s). While sweeping, Run button will now display Stop. Click Stop to end sweeping the network port. Click Single (to the left of Run) to sweep the network port only once.  +
- +
- +
- +
- +
- +
-{{tag>analog-discovery-studio tutorial}}+