Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| learn:courses:real-analog-chapter-6:start [2017/01/04 23:29] – Martha | learn:courses:real-analog-chapter-6:start [2022/10/04 11:38] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Real Analog: Chapter 6 ====== | ====== Real Analog: Chapter 6 ====== | ||
| + | [[{}/ | ||
| + | --> | ||
| + | * Lecture Material: | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * [[http:// | ||
| + | * [[http:// | ||
| + | * [[http:// | ||
| + | * Chapter 6 Videos: | ||
| + | * [[http:// | ||
| + | * [[http:// | ||
| + | * [[http:// | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | * {{ : | ||
| + | |||
| + | <-- | ||
| + | |||
| ====== 6. Introduction and Chapter Objectives ====== | ====== 6. Introduction and Chapter Objectives ====== | ||
| So far, we have considered circuits that have been governed by algebraic relations. These circuits have, in general, contained only power sources and resistive elements. All elements in these circuits, therefore, have either __supplied power__ from external sources or __dissipated__ power. For these resistive circuits, we can apply either time-varying or constant signals to the circuit without really affecting our analysis approach. Ohm’s law, for example, is equally applicable to time-varying or constant voltages and currents: | So far, we have considered circuits that have been governed by algebraic relations. These circuits have, in general, contained only power sources and resistive elements. All elements in these circuits, therefore, have either __supplied power__ from external sources or __dissipated__ power. For these resistive circuits, we can apply either time-varying or constant signals to the circuit without really affecting our analysis approach. Ohm’s law, for example, is equally applicable to time-varying or constant voltages and currents: | ||
| Line 228: | Line 257: | ||
| $${f} \left( t \right) = Ae^{-at}$$ | $${f} \left( t \right) = Ae^{-at}$$ | ||
| - | Where $a>0$. The function ${f}(t)$ is illustrated in Figure 6.18. The value of the function is //A// at $t = 0$ and decreases to zero as $t \rightarrow \infty$. As $t \rightarrow -infty$ the function increases without bound. The constant a dictates the rate at which the function decreases as time increases. | + | Where $a>0$. The function ${f}(t)$ is illustrated in Figure 6.18. The value of the function is //A// at $t = 0$ and decreases to zero as $t \rightarrow \infty$. As $t \rightarrow -\infty$ the function increases without bound. The constant a dictates the rate at which the function decreases as time increases. |
| {{ : | {{ : | ||
| Line 242: | Line 271: | ||
| Or, using the unit step function to limit the function to positive values of time: | Or, using the unit step function to limit the function to positive values of time: | ||
| - | $${f} \left( t \right) = Ae\frac{1t}{\tau} \cdot u_o \left( t \right) | + | $${f} \left( t \right) = Ae\frac{-t}{\tau} \cdot u_o \left( t \right) |
| The function of equations (6.10) and (6.11) is illustrated in Figure 6.19. The time constant, $\tau$, is a positive number which dictates the rate at which the function will decay with time. When the time $t = \tau, {f} \left( t \right) Ae^{-1} = 0.368A$ and the function has decayed to 36.8% of its original value. In fact, __the function decreases by 36.8% every $\tau$ seconds__. Therefore, a signal with a small time constant decays more rapidly than a signal with a large time constant, as illustrated in Figure 6.20. | The function of equations (6.10) and (6.11) is illustrated in Figure 6.19. The time constant, $\tau$, is a positive number which dictates the rate at which the function will decay with time. When the time $t = \tau, {f} \left( t \right) Ae^{-1} = 0.368A$ and the function has decayed to 36.8% of its original value. In fact, __the function decreases by 36.8% every $\tau$ seconds__. Therefore, a signal with a small time constant decays more rapidly than a signal with a large time constant, as illustrated in Figure 6.20. | ||
| Line 262: | Line 291: | ||
| * An exponential function, defined for $t>0$, is mathematically defined as: | * An exponential function, defined for $t>0$, is mathematically defined as: | ||
| - | $${f} \left( t \right) = AE^\frac{-t}{\tau} \cdot u_0 \left( t \right)$$ | + | $${f} \left( t \right) = Ae^\frac{-t}{\tau} \cdot u_0 \left( t \right)$$ |
| The function has an initial value, $A$, and a time constant, $\tau$. The time constant indicates how quickly the function decays; the value of the function decreases by 63.2% every $\tau$ seconds. Exponential functions are important to use because the solutions of linear, constant coefficient, | The function has an initial value, $A$, and a time constant, $\tau$. The time constant indicates how quickly the function decays; the value of the function decreases by 63.2% every $\tau$ seconds. Exponential functions are important to use because the solutions of linear, constant coefficient, | ||
| Line 334: | Line 363: | ||
| ==== Example 6.3 ==== | ==== Example 6.3 ==== | ||
| - | If the voltage as a function of time across a capacitor with capacitance $C = 1\muF$ is as shown below, determine the current as a function of time through the capacitor. | + | If the voltage as a function of time across a capacitor with capacitance $C = 1 \mu F$ is as shown below, determine the current as a function of time through the capacitor. |
| {{ : | {{ : | ||
| Line 527: | Line 556: | ||
| - Determine voltage divider relationships to provide $v_1$ and $v_2$ for the two uncharged series capacitors shown below. Use your result to determine $v_2$ if $C_1 = C_2 = 10 \mu F$. | - Determine voltage divider relationships to provide $v_1$ and $v_2$ for the two uncharged series capacitors shown below. Use your result to determine $v_2$ if $C_1 = C_2 = 10 \mu F$. | ||
| - | ==== 6.4: Inductors ==== | + | ===== 6.4: Inductors |
| We continue our study of energy storage elements with a discussion of // | We continue our study of energy storage elements with a discussion of // | ||
| Line 544: | Line 573: | ||
| {{ : | {{ : | ||
| - | We will denote the total magnetic flux created by the inductor by , as shown in Figure 6.28. For a linear inductor, the flux is proportional to the current passing through the wound wires. The constant of proportionality is the inductance, //L//: | + | We will denote the total magnetic flux created by the inductor by $\psi$, as shown in Figure 6.28. For a linear inductor, the flux is proportional to the current passing through the wound wires. The constant of proportionality is the inductance, //L//: |
| $$\psi(t) = Li(t) (Eq. 6.26)$$ | $$\psi(t) = Li(t) (Eq. 6.26)$$ | ||
| Line 599: | Line 628: | ||
| * In the time period 0<t<1 msec, the voltage is constant and positive so the current will increase linearly. The total current change during this time period is the area under the voltage curve curve, divided by the inductance: $\frac{1}{0.01}(10V)(1x10^{-3} sec) = 1A$ | * In the time period 0<t<1 msec, the voltage is constant and positive so the current will increase linearly. The total current change during this time period is the area under the voltage curve curve, divided by the inductance: $\frac{1}{0.01}(10V)(1x10^{-3} sec) = 1A$ | ||
| * In the time period $1< | * In the time period $1< | ||
| - | * In the time period $2< | + | * In the time period $2< |
| * In the time period 3<t<4 seconds, the voltage is zero. The integral of zero over any time period is zero, so there is no change in current during this time range and the current remains constant at 0A. | * In the time period 3<t<4 seconds, the voltage is zero. The integral of zero over any time period is zero, so there is no change in current during this time range and the current remains constant at 0A. | ||
| Line 631: | Line 660: | ||
| As was previously done for capacitors, we integrate the power with respect to time to get the energy stored in the inductor: | As was previously done for capacitors, we integrate the power with respect to time to get the energy stored in the inductor: | ||
| - | $$W_L(t) = \sum_{-\infty}^{t}Li(\xi}\frac{di(\xi}{dt}dt$$ | + | $$W_L(t) = \sum_{-\infty}^{t} Li(\xi)\frac{di(\xi)}{dt}dt$$ |
| Which, after some manipulation (comparable to the approach taken when we calculated energy storage in capacitors), | Which, after some manipulation (comparable to the approach taken when we calculated energy storage in capacitors), | ||
| Line 736: | Line 765: | ||
| {{ : | {{ : | ||
| + | |||
| + | [[{}/ | ||
| + | [[{}/ | ||