Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
daq-and-datalogging:documents:ulx-for-ni-labview-2 [2023/07/17 06:18] – Scandiwebdaq-and-datalogging:documents:ulx-for-ni-labview-2 [2023/07/28 00:51] (current) – Arthur Brown
Line 1: Line 1:
-====== Getting started with ULx for NI LabVIEW Part 2 ======+====== Getting Started with ULx for NI LabVIEW Part 2 ======
  
 In part one, we learned how what is the minimum amount of VIs needed to acquire one analog data sample and display it on the NI LabVIEW front panel.  In part 2 we will add to this example by including: In part one, we learned how what is the minimum amount of VIs needed to acquire one analog data sample and display it on the NI LabVIEW front panel.  In part 2 we will add to this example by including:
Line 73: Line 73:
    
  
-In its current state, this example can run indefinitely.  That is, as long as the [[https://www.mccdaq.com/usb-data-acquisition/USB-1608G-Series.aspx | USB-1608G]] stays connected, powered, and so long as no external influence damages the device.  But what is something like that should occur?  We would want 2 things to happen.  First we’d want to stop the procedure, in this case our loop, and second, we’d want to be notified there was a problem.  To handle these matters, we add error handling.+In its current state, this example can run indefinitely.  That is, as long as the [[https://digilent.com/shop/mcc-usb-1608g-series-high-speed-multifunction-usb-daq-devices/|USB-1608G]] stays connected, powered, and so long as no external influence damages the device.  But what is something like that should occur?  We would want 2 things to happen.  First we’d want to stop the procedure, in this case our loop, and second, we’d want to be notified there was a problem.  To handle these matters, we add error handling.
  
    
Line 87: Line 87:
 </WRAP> </WRAP>
  
-Run this now, then remove the USB cable from the [[https://www.mccdaq.com/usb-data-acquisition/USB-1608G-Series.aspx | USB-1608G]].  You should see the following error message pop up:+Run this now, then remove the USB cable from the [[https://digilent.com/shop/mcc-usb-1608g-series-high-speed-multifunction-usb-daq-devices/|USB-1608G]].  You should see the following error message pop up:
  
 <WRAP centeralign> <WRAP centeralign>