Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
chipkit_shield_network:refmanual [2015/05/28 18:17] – [Pins Useb by CAN Interfaces] Marthachipkit_shield_network:refmanual [2022/10/04 11:38] (current) – external edit 127.0.0.1
Line 517: Line 517:
 the termination resistors and jumpers to the termination resistors and jumpers to
 enable/disable them depending on the location enable/disable them depending on the location
-of the board in the network. Jumper JP6 is+of the board in the network. Jumper JP2 is
 used to enable/disable the termination resistor used to enable/disable the termination resistor
-for the CAN1 network, and JP8 is used to+for the CAN1 network, and JP7 is used to
 enable/disable the termination resistor for enable/disable the termination resistor for
 CAN2. Install a shorting block on the jumper CAN2. Install a shorting block on the jumper