Table of Contents
Discovery Power Supply (DPS3340) Specifications
Under Construction!
These specifications are valid following 
minutes of warm-up and are typical at °C unless otherwise noted.
Power Supplies
All channels are independently controllable with independent current and voltage settings.
| Specification | Output 1 | Output 2 | Output 3 | |
|---|---|---|---|---|
| DC Output Rating | Voltage | 1 V to 5 V | -1 V to -15 V | 1 V to 15 V |
| Current | 10 mA to 3 A | -10 mA to -500 mA | 10 mA to 500 mA | |
| Maximum Power | 30 W (all channels, shared) | |||
| 15 W | 7.5 W | 7.5 W | ||
| DC Accuracy | Voltage | ±5mV - $\left| \right.$Iout$\left| \right.$ $\cdot$ 0.05 mV/mA | ±15mV + $\left| \right.$Iout$\left| \right.$ $\cdot$ 0.1 mV/mA | ±15mV - $\left| \right.$Iout$\left| \right.$ $\cdot$ 0.1 mV/mA |
| Current | 10 mA | 10 mA | 10 mA | |
| Load Regulation | Voltage | not applicable! | not applicable! | not applicable! |
| Current | not applicable! | not applicable! | not applicable! | |
| Line Regulation | Voltage | not applicable! | not applicable! | not applicable! |
| Current | not applicable! | not applicable! | not applicable! | |
| Ripple and Noise | Voltage (20 MHz Bandwidth): | 30 mV p-p | 10 mV p-p | 25 mV p-p |
| Current (20 MHz Bandwidth): | 7 mA p-p | 5 mA p-p | 3 mA p-p | |
| Setting Resolution | Voltage | 0.36 mV | 0.97 mV | 0.97 mV |
| Current | 0.19 mA | 0.03 mA | 0.03 mA | |
| Meter Resolution | Voltage (across -16V….+16V interval) | 7.8 mV | 7.8 mV | 7.8 mV |
| Current (across -Imax….+Imax interval) | 0.29 mA | 0.29 mA | 0.29 mA | |
| Meter Accuracy | Voltage | ±30 mV | ±15 mV | ±15 mV |
| Current | ±10 mA | ±5 mA | ±5 mA | |
Isolation Voltage
Device isolated from network through external supply. Outputs share a common GND between them and with the host PCB USB connector.
Protection Circuitry
All three supplies feature overcurrent protection through software-settable current limits that can be applied individually to each channel. Same-polarity aggressor protection and reverse voltage protection work up to ±15 V.
Tracking Mode
When the software-implemented tracking mode is active, Outputs 2 and 3 will track each other in absolute value by applying any voltage change made to one channel's setting to the other channel. E.g. if Output 1 is set to 12 V, then Output 2 will be automatically set to -12 V.
Connectivity
The DPS3340 requires a host computer running the WaveForms software connected via USB to operate.
| Device to Computer Interface | USB 2.0 Hi-Speed, Type B. |
|---|
Power Requirements
The DPS3340 requires an auxiliary power supply.
| Power Supply Voltage | 19 V +/- 5% - kitted with …. |
|---|---|
| Power Supply Current | 3.2 A maximum |
| Power Consumption | 60 W maximum |
| Barrel Connector Size | 5.5 mm x 1.65 mm |
Physical Characteristics
| Dimensions | 23.40 cm x 19.40 cm x 3.81 cm (9.2 in x 7.6 in x 1.5 in) |
|---|---|
| Weight | kg ( lbs) |
Environmental
| Operating Temperature | 0 °C to 40 °C (32 °F to 104 °F) |
|---|---|
| Storage Temperature | -20 °C to 60 °C (-4 °F to 140 °F) |
| Operating Humidity | 10% to 80% RH non-condensing |
| Storage Humidity | 5% to 95% RH non-condensing |
| Cooling | Convection-cooled. Ensure the ventilation holes are not obstructed. 1) 2) |
| Pollution Degree | 2 |
| Maximum Altitude | 2,000m |
Indoor use only