====== Mode Selection on the Analog Discovery Pro (ADP3450/ADP3250) ======
<WRAP group><WRAP column half>
Mode selection can be done through WaveForms using the Device Manager. With the Analog Discovery Pro connected to the host computer by USB, **open** WaveForms. If the Device Manager hasn't opened yet, then **click** Settings -> Device Manager.
</WRAP><WRAP column half>
{{ reference:test-and-measurement:analog-discovery-pro-3x50:settings-devicemanager.png?400 |}}
</WRAP></WRAP>
----
<WRAP group><WRAP column half>
Select the Analog Discovery Pro from the list of devices, then **click** the Boot button. The Boot Mode window will open.
</WRAP><WRAP column half>
{{ reference:test-and-measurement:analog-discovery-pro-3x50:selectbootmode.png?400 |}}
</WRAP></WRAP>
----
<WRAP group><WRAP column half>
By default, Standard Mode is selected.

To switch to Linux Mode, select Linux, then **click** "Apply & Reboot".
</WRAP><WRAP column half>
{{ reference:test-and-measurement:analog-discovery-pro-3x50:boot-mode-select.png?400 |}}
</WRAP></WRAP>
----
<WRAP group><WRAP column half>
At this time, an audible click will be heard and the Analog Discovery Pro will disconnect from WaveForms. About 10-15 seconds will pass as it boots and reconnects. Confirm that the second column in your device's entry in the list says "USB:LX", confirming the mode has successfully been switched.
</WRAP><WRAP column half>
{{ reference:test-and-measurement:analog-discovery-pro-3x50:linux-mode-device.png?400 |}}
</WRAP></WRAP>
<--