~~NOTOC~~ 
   
====== Pmod ISNS20  ======
  
{{Digilent Infobox
| Manual = [[reference-manual]]
| Support = https://forum.digilentinc.com/forum/7-add-on-boards/
| Title = Pmod ISNS20
| Subtitle = 20A Current Sensor
| Header = Features
| Bullet = High accuracy current sensor
| Bullet = Measure current with 120Hz/20kHz/80kHz jumper selections
| Bullet = ±20A DC or AC input
| Bullet = Accurate to within ±2%
| Bullet = 12-bit ADC
| Bullet = 6-pin Pmod port with SPI interface
| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}} Type 2
| Header = Applications
| Bullet = Current measurement
| Bullet = Power metering
| Bullet = Closed loop current control
| Bullet = Over-current protection
| Header = Electrical
| Bus = [[learn/fundamentals/communication-protocols/spi/start | SPI]]
| Specification Version = 1.2.0
| Logic Level = 3.3V
| Header = Physical
| Width = 1.3 in (3.30 cm)
| Length = 0.80 in (2.03cm)
| Header = Documentation
| Primary IC = [[http://www.allegromicro.com/en/Products/Current-Sensor-ICs/Zero-To-Fifty-Amp-Integrated-Conductor-Sensor-ICs/ACS722.aspx | ACS722]], [[http://www.ti.com/lit/ds/symlink/adcs7476.pdf | ADCS7476]]
| Reference Manual = [[pmod/pmodisns20/reference-manual]]
| Schematic = {{reference:pmod:pmodisns20:pmodisns20_sch.pdf| }}
| Header = J1 Pinout
| Full Row = {{ :reference:pmod:pmod-pinout-1x6.png?direct |}}
| Pin 1 = CS
| Pin 2 = NC
| Pin 3 = MISO
| Pin 4 = CLK
| Pin 5 = GND
| Pin 6 = VCC
}}

{{page>reference-manual}} \\ \\
 


===== Example Projects =====

No programmable logic example projects are available for the Pmod ISN20

----

===== Additional Resources =====
  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}}

----

{{tag>pmod pmod-start pmod-spi pmodisns20 current-sense dac resource-center}}