====== Pmod DIP Reference Manual ======
The Digilent Pmod DIP is a 12-pin Dual-Inline Package (DIP) that also includes a 2x6 female Pmod™ header, allowing users to easily separate and process any signals traveling to and from their 12-pin Pmod. It allows for easy use of Digilent Pmods in DIP sockets and solderless breadboards.

{{Digilent Image Gallery 
| image = {{:reference:pmod:pmoddip:pmoddip-0.png?direct |}}
| image = {{:reference:pmod:pmoddip:pmoddip-1.png?direct |}}
| image = {{:reference:pmod:pmoddip:pmoddip-2.png?direct |}}
| image = {{:reference:pmod:pmoddip:pmoddip-3.png?direct |}}
}} 

== Download This Reference Manual == 
  * {{:reference:pmod:pmoddip:pmoddip_rm.pdf| PDF}}

----

===== Features =====
  * 12-pin dual inline package module
  * 12-pin Pmod port for wire free breadboard connection

----

=====Functional Description =====
The %%Pmod DIP%% utilizes its 12 pass-through channels to route both digital and analog signals to and from the attached Pmod or other module. By being able to plug in the Pmod DIP into a solderless breadboard, external processing of the signals can be easily performed.

----
===== Interfacing with the Pmod =====
The %%Pmod DIP%% communicates with the host board via the [[pmod:communication_protocols:gpio|GPIO protocol]]. As this is a pass-through module, all signals that are applied to each of the lanes will not be modified in any way.

==== Pinout Description Table ====

^  Pmod Header Pin  ^  DIP Header  ^  DIP Pin  |
|  1                |  J2          |  1        |
|  2                |  J2          |  2        |
|  3                |  J2          |  3        |
|  4                |  J2          |  4        |
|  5                |  J2          |  5        |
|  6                |  J2          |  6        |
|  7                |  J3          |  1        |
|  8                |  J3          |  2        |
|  9                |  J3          |  3        |
|  10               |  J3          |  4        |
|  11               |  J3          |  5        |
|  12               |  J3          |  6        |

Any external power applied to the %%Pmod DIP%% must be within the limits that your system board and attached Pmod can handle.
----
===== Physical Dimensions =====
The pins on the pin header are spaced 100 mil apart. The PCB is 0.7 inches long and 0.5 inches wide. 
----
===== Additional Information =====
The schematics of the %%Pmod DIP%% are available {{pmod:pmod:pmoddip_sch.pdf|here}}. 

As this is just a pass through module, no example code exists to properly demonstrate how to use the %%Pmod DIP%%.

If you have any questions or comments about the %%Pmod DIP%%, feel free to post them under the appropriate section ("Add-on Boards") of the [[https://forum.digilentinc.com/|Digilent Forum]].