~~NOTOC~~ ====== Pmod DA3 ====== {{Digilent Infobox | Store Page = https://digilent.com/shop/pmod-da3-one-16-bit-d-a-output/ | Manual = [[reference-manual]] | Support = https://forum.digilentinc.com/forum/7-add-on-boards/ | Title = Pmod DA3 | Subtitle = One 16-bit D/A Output | Header = Features | Bullet = High resolution, 16-bit Digital-to-Analog converter | Bullet = Low noise analog output | Bullet = SMA connector | Bullet = 2.5V reference voltage | Bullet = 6-pin Pmod port with GPIO interface | Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification Type 1}} | Header = Electrical | Bus = [[learn/fundamentals/communication-protocols/spi/start | SPI]] | Specification Version = 1.2.0 | Logic Level = 3.3V | Header = Physical | Width = 1.2 in (3.05 cm) | Length = 0.80 in (2.03cm) | Header = Design Resources | 3D Model = {{reference:pmod:pmodda3:pmodda3_model.zip| 3D Model}} | Fritzing Part = {{reference:pmod:pmodda3:pmodda3.fzpz| Fritzing part}} | Header = Documentation | Primary IC = [[http://www.analog.com/media/en/technical-documentation/data-sheets/AD5541A.pdf | AD5541A]] | Reference Manual = [[pmod/pmodda3/reference-manual]] | Schematic = {{reference:pmod:pmodda3:pmodda3_sch.pdf| }} | Header = J1 Pinout | Full Row = {{ :reference:pmod:pmod-pinout-1x6.png?direct |}} | Pin 1 = ~CS | Pin 2 = DIN | Pin 3 = ~LDAC | Pin 4 = SCLK | Pin 5 = GND | Pin 6 = VCC }} {{page>reference-manual}} \\ \\ ===== Example Projects ===== == Microprocessor== * [[https://www.hackster.io/mmigs/using-the-pmod-da3-with-arduino-uno-4ece75|Using the Pmod DA3 with Arduino Uno]] - Application note ==Programmable Logic== * No programmable logic example projects are available for the Pmod DA3 ---- ===== Additional Resources ===== * [[https://wiki.analog.com/resources/fpga/xilinx/pmod/ad5541a|ZedBoard Demo Project]] * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}} ---- {{tag>pmod pmod-start pmod-spi pmodda3 dac sma resource-center}}